Cutting the splines on the extruder stepper motor was very easy with the spline cutter pictures. below.
The first set of 11 0.7mm splines were cut with a 4mm spacer in place on the dremel spline cutter with 36 steps between each spline the spacer was then removed and another 11 cuts were made making the splines 4mm longer.
Testing the Stepper drive.. and posting my 1st YouTube video.
Heads Up - Off to EverythingOpen for a couple of weeks
-
Minimal updates for a week or two as I'm preparing for and heading to
EverythingOpen in Gladstone, Australia to present on the Quirkey
accessibility keyb...
1 week ago
No comments:
Post a Comment